Tormac single stage centrifugal pumps are providing with axial suction port and radial discharge port. The pump has back pull-out design. State of the art machinery, most advanced pumping technology and expertise gained over the years and employed in the, manufacture of these pumps. Quality raw material, seals, ball bearings and dynamically balanced rotating components are used to ensure long life.
Tormac’s swimming pool pumps are developed with the combination of immense experience, cutting edge technology and integrated quality control system complying with internationally accepted standards. Tormac’s “ TSW” series swimming pool pumps are self-priming type inbuilt with pre filter basket for cleaning the pool water. The mechanical seals are made of graphite and alumina with close tolerance for perfect sealing systems and the dynamically balanced rotary parts ensure vibration and noise free operation. All the parts of both pumps and motors are made of high quality materials to enhance the life span and efficiency. All single phase pumps are equipped with thermal protector to protect the motor from adverse operating conditions.
“Tormac Water Circulatory pumps are used to circulate hot / cold water with adequate pressure in HVAC systems. All parts & components have been uncompromisingly tested to ensure trouble free performance and safety operation. The motor is of 2 pole asynchronous and squirrel cage type and consists of canned rotor portion. All the rotating parts are in touch with pumped liquid and thus it acts as lubricant to rotor, shaft & thrust bearings. An air vent plug is provided in the rear-end. The centrifugal impeller is of radial & closed type with corrosion resistant curved blades. Impeller, shaft with rotor, thrust bearing pad and the intermediate rings are assembled as a single unit to avoid the misalignment of the bearings. The thrust bearing is designed to withstand high axial thrust load. The particular model of pumps are equipped with a rotary switch in the terminal box that can be used to control the speed in 3 different levels based on the requirement. For trouble free operation the temperature of the pumped liquid should not exceed the specified level, the minimum inlet pressure should be maintained (to avoid cavitations) and dry run must totally be avoided. As the motor is impedance protected and consequently short-circuit proof, no additional motor protection is required. The pump is provided with standard length of cable lead out with plug. These circulatory pumps are generally used in tandem with heating systems. “
Tormac single stage centrifugal pumps are providing with axial suction port and radial discharge port. The pump has back pull-out design. State of the art machinery, most advanced pumping technology and expertise gained over the years and employed in the, manufacture of these pumps. Quality raw material, seals, ball bearings and dynamically balanced rotating components are used to ensure long life.
