Specification
Power Range | 0.37 to 2.2 kW |
Version | 1Ph, 230V, 50Hz, AC Supply 3Ph, 380-415V, 50Hz, AC Supply |
Speed | 2900 rpm |
Degree of protection | IP55 |
Insulation Class | Class F |
Duty | S1 |
Tormac TV series Vertical Multistage Pumps are highly reliable and technologically advanced multipurpose pump capable of satisfying the need of a wide variety of users. The in-line design enables the pump to be installed in vertical position and does not interrupt the horizontal pipe line system. All the wet parts like impellers, diffusers, shaft of these pumps are constructed by corrosion resistance AISI stainless steel and designed to deliver the best possible hydraulic efficiency. The integrated and most modern quality assurance systems used at every stage of the production and flawless workmanship ensure sustained and consist operation. These pumps are equipped with replacement mechanical seal.
Tormac TH Horizontal Multistage Centrifugal pumps are specially designed to facilitate pressure boosting and are best suited for a wide range of applications. The vital components viz. impellers, diffusers, and shaft used in these pumps are made of corrosion resistance high quality Stainless Steel which ensure a smooth and trouble free performance helps to pump safe and hygienic drinking water system. The prime mover of this product is robust in construction and built with thermal overload protection (only in single phase motors). High quality mechanical seals are used to ensure less friction / power loss.
“Tormac Water Circulatory pumps are used to circulate hot / cold water with adequate pressure in HVAC systems. All parts & components have been uncompromisingly tested to ensure trouble free performance and safety operation. The motor is of 2 pole asynchronous and squirrel cage type and consists of canned rotor portion. All the rotating parts are in touch with pumped liquid and thus it acts as lubricant to rotor, shaft & thrust bearings. An air vent plug is provided in the rear-end. The centrifugal impeller is of radial & closed type with corrosion resistant curved blades. Impeller, shaft with rotor, thrust bearing pad and the intermediate rings are assembled as a single unit to avoid the misalignment of the bearings. The thrust bearing is designed to withstand high axial thrust load. The particular model of pumps are equipped with a rotary switch in the terminal box that can be used to control the speed in 3 different levels based on the requirement. For trouble free operation the temperature of the pumped liquid should not exceed the specified level, the minimum inlet pressure should be maintained (to avoid cavitations) and dry run must totally be avoided. As the motor is impedance protected and consequently short-circuit proof, no additional motor protection is required. The pump is provided with standard length of cable lead out with plug. These circulatory pumps are generally used in tandem with heating systems. “